OEM Basic Stamp 2 scheda in kit

Il Modulo BASIC STAMP 2 OEM è disponibile in kit da assemblare.

The BASIC Stamp 2 OEM Module (Kit Form) is a through-hole version of the popular BASIC Stamp 2 module. Once assembled, this product is NOT eligible for returning to Parallax.

Features:

• Assembled form factor is a 20-pin SIP (0.1" spacing)
• PC board includes labeled component locations with visible traces between parts
• PBASIC interpreter and EEPROM chips are socketed to allow easy replacement
• Documentation includes bill of materials with multiple sources for each component

Kit Contents:

• 4.7K 1/8W 5% Resistor
• 10K 1/8W 5% Resistor
• 10uF Electrolytic Capacitor
• 0.1uF Mono Radial Capacitor
• 2N3904 Transistor
• 2N3906 Transistor
• PBASIC2C/P 28-pin Interpreter Chip
• 24LC16B EEPROM
• Brown-Out Voltage Detector (4.2 VDC)
• 20 MHz Ceramic Resonator
• LM2940-5.0 Voltage regulator
• Complete Component Listing

Free Downloads:
The BASIC Stamp Editor and BASIC Stamp Manual are available separately as free downloads.

Key Specifications:

• Power Requirements: 5.0 to 7.5 VDC
• Communication: Serial
• Dimensions: 2.0 x 2.0 x 0.55 in (51 x 51 x 14 mm)
• Operating Temperature: +32 to +158 °F (0 to +70 °C) 

Note: That low-power mode is only available when the regulator is removed and the BASIC Stamp 2 OEM module is powered via the vdd pin.  The Parallax warranty is voided if the OEM kit is not assembled and soldered as per the printed instructions included in the kit. Contact Technical Support if you have any questions relating to the assembly of this product.

Once assembled, this product is NOT eligible for returning to Parallax.

Downloads & Recourses:
BASIC Stamp 2 OEM Material (.zip)
BASIC Stamp 2 OEM Manual (.pdf)
BASIC Stamp 2 OEM Schematic (.pdf)
BASIC Stamp OEM Gerber File Details (.zip)
BASIC Stamp FAQ (.pdf)
BASIC Stamp Manual
BASIC Stamp Software